Two different problems with one name
Type one — the fold was lowered. To fit a larger implant or to 'add fullness', the natural fold under the breast was dissected downward. The implant now sits below the old fold, which remains tethered to the chest and shows as a crease running across the lower breast with the implant bulging beneath it. Type two — the tissue slid. The fold and implant stayed where they were, but the breast tissue descended over the implant's lower edge with time, weight change or pregnancy — the cousin of the waterfall deformity. The two look similar from across the room and need different operations.
Who is prone to it
Patients with a tight, constricted lower pole (tuberous or 'constricted' breasts) whose fold sits high and whose skin resists stretching; patients who received implants with a base wider than their breast; and any breast in which the fold was lowered more than a few millimetres. Honest primary planning — respecting the fold, scoring a constricted lower pole from inside, sizing to the base — prevents most cases.
Correcting a lowered fold
The implant is removed and the fold is rebuilt at its correct level with layered internal sutures — the same capsulorrhaphy used for bottoming out. The tethered old crease is released from inside so the skin can redrape. Where tissue is thin, mesh or a matrix supports the new fold. The implant is usually downsized or narrowed; a repaired fold does not tolerate the load that broke the original.
Correcting a constricted lower pole
When the cause is a tight lower pole that never expanded, the gland is scored radially from inside to let it drape over the implant, the crease is released, and small-volume fat grafting fills the step between the two contours. In marked constriction a periareolar or vertical lift reshapes the lower pole; a bigger implant — the instinctive 'fill it out' answer — makes the double contour worse.
Correcting slid tissue
When the tissue has descended over a well-positioned implant, the answer is a lift over the implant, not a lower fold. The implant may be exchanged for a slightly larger or higher-profile device if volume is lacking, but the lift does the work. Timing matters: a double bubble seen in the first weeks is often swelling and a tight pocket that softens by month six; one still present at six months is anatomy. Photographs from the front and side with arms relaxed, via the assessment, let Dr. Erdal sort the type before anything is booked.
Frequently Asked Questions
What is a double bubble after breast augmentation?
A visible second contour: either the implant sitting below the natural fold with the old fold showing as a crease across the lower breast, or the breast tissue sliding down over an implant that stayed put. Both produce two 'bubbles' instead of one smooth lower pole.
Can a double bubble go away on its own?
The early version that comes from swelling or a tight lower pole can soften over 3–6 months as the implant settles. A true double bubble — a lowered fold or a tethered old crease — does not resolve without surgery.
How is a double bubble corrected?
By addressing the cause: rebuilding the fold with internal sutures when it was lowered too far, releasing a tethered old crease, fat grafting to blend the step, downsizing an oversized implant, or lifting breast tissue that has slid off the implant. Often two of these together.